+44 (0)1487 833 600
Wilsons is COVID-19 Compliant

Data Sheets

Aluminium Alloy


5L36 Wire / Rivet Stock

5L36 - 1050A has excellent characteristic properties: Very good atmospheric corrosion resistance. Very good workability. High thermal and electrical conductivity (preferred alloy 1350). Attractive appearance, high reflectivity. Suitable for decorative anodising. Very good weldability with low mechanical properties.

Chemical Composition

BS 5L36(1985)
Alloy 5L36
Chemical Element % Present
Silicon (Si) 0.0 - 0.25
Iron (Fe) 0.0 - 0.40
Magnesium (Mg) 0.0 - 0.05
Titanium (Ti) 0.0 - 0.05
Manganese (Mn) 0.0 - 0.05
Other (Each) 0.0 - 0.03
Zinc (Zn) 0.0 - 0.07
Copper (Cu) 0.0 - 0.05
Aluminium (Al) Balance

Alloy Designations

Aluminium alloy 5L36 - 1050A is covered by Standard BS EN 5L36 (1985) 

Generic Physical Properties

Physical Property Value
Density 2.59 g/cm³
Melting Point 658 °C
Thermal Expansion 23.5 x10^-6 /K
Modulus of Elasticity 69 GPa
Thermal Conductivity 229 W/m.K
Electrical Resistivity 59.5 % IACS

Mechanical Properties

BS 5L36(1985)
Wire -
Mechanical Property Value
Tensile Strength 110 Min MPa


This Data is indicative only and as such is not to be relied upon in place of the full specification. In particular, mechanical property requirements vary widely with temper, product and product dimensions. All information is based on our present knowledge and is given in good faith. No liability will be accepted by the Company in respect of any action taken by any third party in reliance thereon.

Please note that the 'Datasheet Update' date shown above is no guarantee of accuracy or whether the datasheet is up to date.

The information provided in this datasheet has been drawn from various recognised sources, including EN Standards, recognised industry references (printed & online) and manufacturers’ data. No guarantee is given that the information is from the latest issue of those sources or about the accuracy of those sources.

Material supplied by the Company may vary significantly from this data, but will conform to all relevant and applicable standards.

As the products detailed may be used for a wide variety of purposes and as the Company has no control over their use; the Company specifically excludes all conditions or warranties expressed or implied by statute or otherwise as to dimensions, properties and/or fitness for any particular purpose, whether expressed or implied.

Advice given by the Company to any third party is given for that party’s assistance only and without liability on the part of the Company. All transactions are subject to the Company’s current Conditions of Sale. The extent of the Company’s liabilities to any customer is clearly set out in those Conditions; a copy of which is available on request.